High efficiency air-water DC INVERTER heat pump with very high shutting and double refrigerant circuit, R410A refrigerant, fully wired and pre-assembled, designed for heating, cooling and DHW preparation.
Outdoor installation, resistant to atmospheric agents thanks to the hot-dip galvanized sheet and painted, after processing, with polyurethane powders in the oven at 180 °C.
- “Full inverter” Air-Water heat pump
- High efficiency, Energy Class A+
C.O.P. = 3.90
E.E.R. = 3.65
- Extraordinary 1:16 modulation ratio to optimize operating consumption
- Double refrigerant circuit, powered by 6 scroll compressors that ensure reliability and operating safety even in the event of a component failure, avoiding the complete blocking of the machine
- Possibility to configure up to 7 machines in cascade
- Sequential defrosting of the circuits to avoid downtime
- Intelligent electronics that equally shares the operation hours of the compressors, increasing the useful life of the system
- LN silencing as standard, consisting of soundproofed compressor housing, guarantee of reduced noise emissions
- Standard antifreeze kit to optimize the operation of the heat pump in unfavorable temperature conditions, consisting of low absorption heating cables with automatic management and pre-wired electrical connection
- Low energy consumption DC INVERTER fan motors
- Resistance to atmospheric agents guaranteed by galvanized sheet metal casing and polyurethane painting
- Air-gas exchanger in copper pipes and aluminium fins. Geometrically designed to have the highest heat exchange and lowest pressure drops
- Electrical panel board with IP54 protection degree, with dedicated door to facilitate installation and maintenance works
- Control system to monitor and adapt the performance of the inverter compressor, circulator and fan, together with the INVERTER technology and the on-board sensors
- HYDRONIC KIT equipped with:
- Patented high efficiency water-gas, stainless steel plate exchanger for R410A conceived with double refrigerant circuit and single hydraulic circuit.
- Integrated modulating INVERTER circulator
- Circulation and protection flow switch
- Automatic air vent valve, safety valve (6 bar) and fill & drain cock.
- Integrated system configurator with expansion modules for I / O resources and MODBUS connection port
- Flow temperatures: up to 57 °C
- Operating limit outside temperature:
-15 °C (Heating) + 46 °C (Cooling).
